This enum is used by the ScanAndPair APIs to set the notification type. The notifications can be provided to the user to indicate the progress of the different scanning states. This enum provides notification related information during scanning process.The beep sequence is explained in the below table
Beeping Sequence
Notification Stages
Beeper Sequence
Remarks
Scanner Ready
Two short beeps of the same frequency
If the ScanInfo.TriggerType is set to MANUAL, this notification indicates when to press the trigger. Pair Success Four short beeps of the same frequency Indicates that pairing has succeeded. Unpair success Four short beeps of the same frequency Indicates that unpairing has succeeded. Scan Failed Six beeps of alternating frequencies Indicates scanning has failed. Discovery failed Six beeps of alternating frequencies Indicates that the Bluetooth device could not be found. UnPair failed Six beeps of alternating frequencies Indicates that unpairing has failed
Values:
BEEPER -Beeper notification. Raises pre-defined beep sequences. This will give the user an audible alert when specific operations are performed.
NONE -Disable notification. Do not raise notification for any type of operations.